Connections; Connecting The Ac Power Cord; Connection Example - Sony PFM-510A2WU Bedienungsanleitung

Installation / Connections
Side
Hooked on the wall: Vertically
Front
20
(7 7 / )
Wall 8
Make sure that
the control
section is at the
bottom.
Side
14
(GB)
7
3.5 (1 / )
16
Wall
Units: cm (inches)
Wall
10 (4)
25
(9 7 / )
8 Wall
10 (4)
Wall
5 (2)
Wall
Units: cm (inches)

Connections

Connecting the AC Power Cord

1
Plug the power cord into the AC IN socket. Then,
attach the AC plug holder (supplied) to the AC
power cord.
AC IN
socket
2
Slide the AC plug holder over the cord until it
connects to the AC IN socket cover.
To remove the AC power cord
Squeeze the upper and lower sides and pull out the
AC plug holder.

Connection Example

Before you start
• First make sure that the power to each piece of
equipment is turned off.
• Use connecting cables suitable for the equipment to
be connected.
• The cable connectors should be fully inserted into
the jacks. A loose connection may cause hum and
other noise.
• To disconnect the cable, pull it out by grasping the
plug. Never pull the cable itself.
• Read the instruction manual of the equipment to be
connected.
AC power
cord
AC plug
holder
AC IN
socket
cover