Panasonic EYFLA2A Bedienungsanleitung Seite 12

Display
Battery indication lamp
3. Press the
and
desired time.
Display
Buttons
4. Press the OK button to accept the selected
setting.
• The control panel will stop flashing and
light up, and the torque clutch setting
will be displayed.
CAUTION:
• Be sure to verify the new value after
changing the setting.
Initializing All Settings
Factory settings
• Torque clutch setting: "F" (torque con-
trol function off)
• Interval setting: 0 (off)
• This section explains how to revert all tool
settings to their default values at the time of
shipment from the factory.
• The error display will be turned off.
1. Set the tool to configuration mode.
(See page 10.)
2. Press the format button.
• The control panel will begin flashing.
Display: The letter "F" flashes on and off.
Battery indication lamp: The upper and
lower bars of the battery flash on and off.
Display
Battery indication lamp
3. Press the OK button to accept the select-
ed setting.
buttons to set the
Seconds
30 3
0.1
1
0 Off
• The control panel will stop flashing and
light up.
Checking Tool Settings
• This section describes how to have the tool
display current settings for approximately 3
seconds when the tool is stopped.
• You cannot check tool settings when the
control panel is turned off. First, engage
the switch briefly to reactivate the display.
Checking the torque clutch setting
1. Press the torque set button.
• Control panel display
Display: The torque set lights up.
Battery indication lamp: The upper bar of
the battery flashes on and off.
Checking the interval
1. Press the interval set button.
• Control panel display
Display: The interval set lights up.
Battery indication lamp: The middle bar
of the battery flashes on and off.
Checking tool circuits
1. Press the torque set button.
• Control panel display
Display: The torque set display lights up.
Battery indication lamp: The middle and
lower bars of the battery flash on and off.
Display
H
H3
H4
NOTE:
• If you engage the switch while a setting
is being displayed, the control panel will
revert to the torque clutch setting dis-
play.
CAUTION:
• The torque set display is not intended
to be used to identify the type of drive
component parts (hammer, etc.) used
in a particular tool.
- 1 -
Tool circuit
EYFLA1
EYFLA
EYFLA3