Se�Ng Up And Opera�Ng The Projector - PHOS 45s pole mount pro Nutzungsinformation

4. Se�ng up and opera�ng the projector
WARNING! Risk of burns!
You can burn yourself on projector parts which have become hot.
▶ Let the device cool for at least 10 minutes before any set-up work.
WARNING! Op�cal radia�on hazard!
Op�cal radia�on can cause temporary or permanent eye damage.
▶ Never stare directly into the beam of light.
Some of the steps below require the projector to be switched on. Op�cal radia�on can cause high temperatures at close
range and may be dangerous for your eyes. Exercise appropriate cau�on. Only switch on the projector once the gobo has
been inserted. Carry out set-up work as soon as possible a�er switching on the device.
Avoid the entry of moisture or water when se�ng up the projector. Remove visible drops of water immediately with a dry
cloth. During opera�on, water can condense on the front glass and affect projec�on. To prevent this, a desiccant bag is
a�ached above the lens to bind moisture from the ambient air. This process takes several days. If water con�nues to con-
dense on the front glass, check the sealing and replace the desiccant bag (see chapter 4.6).
A few se�ngs s�ll need to be made to the projector head
in order to set up projec�on as you wish.
• Carefully remove the shell from the projector head.
38 / 76
Se�ngs
Derksen Lich�echnik