Connec�Ng Op�On For Ligh�Ng Control (Dali / 1-10V) - PHOS 45s pole mount pro Nutzungsinformation

7. Release the connec�on terminals and remove the pre-
assembled cable.
8. Ensure the mains voltage matches the input voltage of
the projector as specified in the technical specifica-
�ons (220 – 240 V AC, 50 / 60 Hz) and your supply
cable is connected to a protec�ve conductor via the
corresponding contact on the terminal block.
9. Tighten the cable gland.
3.6. Connec�ng op�on for
ligh�ng control (DALI / 1–10V)
In addi�on to the basic version, the PHOS s pole mount pro
is also available as either a DALI or a 1–10V version. Com-
pared to the basic version, these offer the possibility, to
switch the projector on and off and to change its brightness
via a ligh�ng control system.
Depending on the version, either a 1-10V line or a DALI line
can be connected to the two-pole connec�on terminal in
the device stand.
ATTENTION! Poten�al Damage
A ven�la�on element has been installed next to the
cable gland. This must NOT be dismantled, rotated or
modified in any way. This is the only way to ensure its
waterproof capability.
1. Release the cable gland on the back of the device and
remove the blind plug.
2. Feed your control cable in and connect it to the two-
pin terminal.
3. Tighten the cable gland.
PHOS s pole mount pro
Installa�on
37 / 76