3.2. Fitting the mounting bracket
When completing the following steps, ensure that you fit
the screws, spring rings and washers in the sequence spe-
cified. Use the hexagon socket wrench supplied to do so.
1. Slide the mounting bracket over the threaded pin of
the mounting plate.
2. Fasten the mounting bracket with the self-locking nut
M10 (a.), spring washer M10 (b.) and washer M10 (c.)
3. Align the mounting bracket and mount the cylinder
head screw M6 x 16 (a.) with spring washer M6 (b.)
and washer M6 big (c.)
4. Check that the articulated bracket is firmly seated on
the mounting plate.
3.3. Moun�ng the projector
1. Posi�on the device stand on the moun�ng bracket so
that the threaded holes in the base plate line up with
the holes in the moun�ng bracket.
PHOS s pole mount
Moun�ng
c.
a. b.
c.
a. b.
33 / 76