Specifications; Specific Safety Rules - Makita BHP444 Betriebsanleitung

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Switch trigger
5. Lamp
6. Reversing switch lever
7. Speed change lever
8. Action mode change lever
9. Adjusting ring
10. Graduation
11. Arrow

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute (min
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to
hammer drill safety rules. If you use this power tool
unsafely or incorrectly, you can suffer serious
personal injury.
Explanation of general view
12. Steel band
13. Grip base
14. Side grip
15. Protrusion
16. Groove
17. Sleeve
18. Bit holder
19. Bit
20. Depth rod
21. Clamp screw
22. Hook
Model
Concrete
Steel
Wood
Wood screw
Machine screw
High (2)
-1
)
Low (1)
High (2)
-1
)
Low (1)
Overall length
Net weight
Rated voltage
6 mm x 75 mm
1. Wear ear protectors when impact drilling.
ENE039-1
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
GEA010-1
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
4. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
5. Hold the tool firmly with both hands.
6. Keep hands away from rotating parts.
7. Do not leave the tool running. Operate the tool
only when hand-held.
8. Do not touch the bit or the workpiece immediately
GEB003-4
after operation; they may be extremely hot and
could burn your skin.
9. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
23. Screw
24. Blow-out bulb
25. Limit mark
26. Rear cover
27. Screws
28. Arm
29. Spring
30. Recesed part
31. Carbon brush cap
32. Hole
BHP444
14 mm
13 mm
50 mm
6 mm
0 - 1,700
0 - 400
0 - 25,500
0 - 6,000
243 mm
2.3 kg
D.C. 14.4 V
BHP454
16 mm
13 mm
65 mm
10 mm x 89 mm
2.4 kg
D.C. 18 V
5