Specifications - Makita DDF485RFE Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Red indicator
1-2. Button
1-3. Battery cartridge
2-1. Star marking
3-1. Switch trigger
4-1. Lamp
5-1. Reversing switch lever
6-1. Speed change lever
7-1. Action mode change lever
8-1. Adjusting ring
8-2. Graduation

SPECIFICATIONS

Capacities
-1
No load speed (min
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for drilling and screw driving in wood,
metal and plastic.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB (A)
The noise level under working may exceed 80 dB (A).
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
8-3. Arrow
9-1. Steel band
9-2. Grip base
9-3. Side grip
9-4. Protrusion
9-5. Groove
10-1. Sleeve
11-1. Bit holder
11-2. Bit
12-1. Groove
12-2. Hook
Model
Steel
Wood
Wood screw
Machine screw
High (2)
)
Low (1)
Overall length
Net weight
Rated voltage
) : 73 dB (A)
pA
2
) : 2.5 m/s or less
h,D
2
DDF444
13 mm
50 mm
6 mm x 75 mm
2.2 kg
D.C. 14.4 V
ENE034-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENG905-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
ENG900-1
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
4
12-3. Screw
14-1. Limit mark
15-1. Rear cover
15-2. Screws
16-1. Arm
16-2. Spring
16-3. Recessed part
17-1. Carbon brush cap
18-1. Hole
18-2. Carbon brush cap
DDF454
13 mm
65 mm
10 mm x 89 mm
6 mm
0 - 1,700
0 - 400
231 mm
2.3 kg
D.C. 18 V
ENG901-1