Timer Mode - AquaForte IH30 Gebrauchs- Und Installationsanleitung

5.5 Manual-Inverter Mode
1
Hold
2
Press
3 The running capacity could be adjusted from 30% ~ 100% , by
pressing
4
Press
5.6 Auto-Inverter Mode
According to the set water flow, the pump could automatically detect the system pressure to
adjust the speed of motor, to ensure a constant flow.
1
Unlock the screen, press
Auto-Inverter mode.
2
Press
3
Press

5.7 Timer mode

The pump's on/off and running capacity could be commanded by timer, which could be
programmed daily as needed.
1
Enter timer setting by pressing
2
Press or
3
Press to confirm and move to time-1 setting
4
Press or
or flow
7
for more than 3 seconds to unlock the screen;
to start. The pump will run at 80% capacity after priming.
or with 5% for each step.
to check the instant flow of the running capacity, and press
again will back to the running capacity interface.
or to set the flow rate, each step by 1m³/h.
again to switch to Manual-Inverter mode.
to set the local time
to choose the desired running periods and specific capacity
to shift from the Manual-Inverter mode to