Important Safety Instructions - AquaForte IH30 Gebrauchs- Und Installationsanleitung

1.

IMPORTANT SAFETY INSTRUCTIONS

This guide provides installation and operation instructions for this pump. If you have any other
questions about this equipment, please consult your supplier.
1.1 When installing and using this electrical equipment, basic safety precautions
should always be followed, including the following:
•RISK OF ELECTRICAL SHOCK. Connect only to a branch circuit protected by a ground-fault
circuit-interrupter (GFCI). Contact a professionally trained and qualified electrician if you
cannot verify that the circuit is protected by a GFCI.
•This pump is for use with permanently installed in-ground or above-ground swimming pools
and may also be used with hot tubs and spas with a water temperature under 50℃. Due to the
fixed installation method, this pump is not suggested to be used on above-ground pools that
can be readily disassembled for storage.
• The pump is not submersible.
• Never open the inside of the drive motor enclosure.
1.2 All installations must be fitted with earth leakage or residual current protection
devices, having a rated residual operating current not exceeding 30mA.
WARNING:
• Fill the pump with water before starting. Do not run the pump dry. In case of dry run,
mechanical seal will be damaged and the pump will start leaking.
• Before servicing the pump, switch OFF power to the pump by disconnecting the main circuit
to the pump and release all pressure from pump and piping system.
• Never tighten or loosen screws while the pump is operating.
• Ensure that the inlet and outlet of the pump are unblocked with foreign matter.
1