Error Code - AquaForte IH30 Gebrauchs- Und Installationsanleitung

7.4 Error code

When the device detects a failure (except for the running capacity reduction strategy and 485
communication failure), it will power off automatically and display the failure code. After power
off for 15 seconds, check if the failure is cleared, if cleared, it will resume to start.
Item Error Code
1 E001
2 E002
3 E101
4 E102
5 E103
6 E104
7 E105
8 E106
9 E107
10 E108
11 E201
12 E202
13 E203
14 E204
15 E205
16 E206
17 E207
Note:
1. When causes for E002/E101/E103 is displayed, the device will resume working
automatically, however when it appears a fourth time, the device will stop working, to resume
operation, unplug the device and plug in & restart again.
13
Description
Abnormal input voltage
Output over current
Heat sink over heat
Heat sink sensor error
Master driver board error
Phase-deficient protection
AC current sampling circuit failure
DC abnormal voltage
PFC protection
Motor power overload
Circuit board error
Master board EEPROM reading failure
RTC time reading error
Display Board EEPROM reading failure
Communication Error
RS485 communication Error
Low water level