General Instructions; Getting To Know Your Safety Seat - JANE CONCORD IKONIC R Bedienungsanleitung

C_GENERAL INSTRUCTIONS
In order to protect your baby adequately and to ensure their
comfort and stability in the car, the following instructions must
be strictly followed:
This seat is only suitable for cars fitted with the ISOFIX anchoring
system, approved under Regulation ECE-14 or other equivalent
standards.
Your IKONIC R safety seat can be installed on the front seat, if it
is not fitted with an airbag, or back seat of your vehicle. However,
we advise you to install it on the back seat. If it is installed on the
front seat of the vehicle, make sure it IS NOT fitted with an air
bag, or that the airbag is disconnected. You should also check
the Traffic Law of the country where you are driving.
Not all safety systems are exactly the same, therefore we advise
you to check your IKONIC R in the car in which it is going to be
fitted.
It is very important not to use second-hand products, as JANÉ-
CONCORD can only guarantee complete safety with items used
by their first buyer.
JANÉ-CONCORD recommends that you replace your IKONIC R
safety seat with a new one if it has been subjected to violent
stress in an accident.
Check that all the seat straps are in the correct position and duly
adjusted to your IKONIC R. Make sure that none of the straps are
twisted. The child must understand that he must not play with the
straps or fasteners under any circumstances.
Do not install the safety seat on sideways seats in the vehicle or
rear facing seats, this is very dangerous.
20
EN
D_GETTING TO KNOW YOUR
SAFETY SEAT
Your IKONIC R safety seat has been designed taking into
account the latest advances in terms of safety and it has
been tested under the toughest conditions. It has the
following features:
Installing in the vehicle:
Ready for easy installation with the ISOFIX system (See section
INSTALLING THE SEAT IN THE CAR of these instructions).
Comfort and safety for the baby:
The child restraint harness is fitted with the "Holmbergs RollFix
system that retracts the seat belts. This system retracts the excess
belt and keeps it snug against the body at all times.
Integrated 5-point harness, with a greater fastening area, so distributing
the loads on the baby better in the event of an accident.
Ventilation in the shell making it more breathable.
Impact absorbing material over the entire surface in contact with
the baby.
Adjustable headrest with 5 different positions.
The safety seat can be reclined.
Fitted with insert for babies from 40 to 60 cm in height.
Convenience for parents:
The height of the shoulder straps can be adjusted without having to
take the straps off. This action is connected to the headrest so it
protects the baby better in the event of a side impact while supporting
the head.
The seat can be turned to face the door making it easier to place
the baby in it.
Removable and washable upholstery.
TM "