DNT UltraZoom PRO Bedienungsanleitung Seite 52

- Open the calibration tool
the option "Reset Picture Magnification".
- Carry out a new calibration completely as described in the chapter "Calibration".
- Change the magnification rate in this way and take some pictures. Load them into
the measuring and editing interface again by double-clicking on them in the list of
images on the right.
- Here, you open the calibration tool
again and select the item "Set
Magnification" as well as the option
2. Change the magnification rate and capture several
„Reset Picture Magnification".
pictures, click on the picture to enter into measurement
- In the following dialogue window, enter
the current magnification rate, which is
interface. And click '
accepted after clicking on "OK".
picture magnification', now a dialog will show up as below;
enter the magnification rate into the dialog and click 'OK'.
- If you want to transfer this magnification rate to other loaded images, open the
3. If you want to use the same magnification rate to
calibration tool
interface and select the item "Set Capture Magnification" and the option "Set
Capture Magnification".
capture pictures,
- In the following dialogue window, you can now enter the current enlargement rate,
magnification >Set capture magnification'. Now all
which is accepted after clicking on "OK".
pictures will use the same magnification rate and you can
start measurement directly.
52
focus
magnification rate again.
1. Double click to open the picture, Click '
Reset magnification > Reset picture magnification' as
below. And then start calibration again (Calibration details
please refer to page24).
> Set magnification > Set
after loading the image into the measuring and editing
just 36 click '
to capture picture,
and select the item „Reset Magnification" and
> Set
please calibrate
35
the
>