Safety Instructions; Usage Instructions; Maintenance And Storage; Disposal Advice - Hudora 83046 Aufbau- Und Gebrauchsanleitung

CONTENTS
1 pair of palm protectors
1 pair of elbow protectors
1 pair of knee protectors
1 instruction manual
Other items are meant to facilitate safe transportation and are not required for the instal-
lation and use of the product.

SAFETY INSTRUCTIONS

• These protectors are suitable for users of cycles, skateboards, roller skates and inline
skates. These protectors are not suitable for use on motorcycles. They are not suita-
ble for acrobatic or high-speed skateboarding and skating.
• Your protectors must fit correctly, so that they do not move during a fall. Before you
get moving make sure that everything is positioned correctly. The protectors should
sit comfortably. It is extremely important to first make sure that the protectors offer
you sufficient free room even when closed. Take care not to risk cutting off your
blood circulation. Remember never to skate without your protectors and a helmet!
• Before each use, especially after a fall or accident, check the protectors for damage.
The protectors should be discarded and replaced if the shell shows denting, crack-
ing, deep scratches or discolorations / the padding underneath the shell is compact-
ed or holed / the straps never no longer fasten, have become overstretched, torn or
abraded / the protectors no longer fit or cover the intended areas!
• Do not make modifications in any way that may impair the safety of the products!
• Even under the correct use, you protectors cannot guarantee you 100% protection
against injury. Always carry out your sport carefully. To reduce the risk of injury,
skate sensibly and within your ability.
• The protectors will only offer limited protection in the even to flow velocity impacts
with stationary hard surfaces!
• These protectors are not intended to provide protection in the event of a serious fall
when travelling at speeds in excess of 13 km/h!
• They will not protect the wearer in the event of the collisions with moving vehicles!
• Changes in environmental conditions, such as temperature, would significantly re-
duce the performance of the protector!
• Contamination, alteration to the protector, or misuse would dangerously reduce the
performance of the protector!
• In the case of proper maintenance and storage, the maximum service life of the pro-
tectors is 7 years after the production date. After this period, the protectors must
be replaced.

USAGE INSTRUCTIONS

The size classes are just for orientation. If the protectors do not sit firmly and comfort-
ably another size should be chosen.
The anatomically formed shells (PP) offer a great fit, high wearing comfort and keep
joints in their correct position. The tough shell and padding (EVA) minimise shock
during a gall and prevent rubbing and nicks. The major materials are nylon, EVA, pol-
yester and PP (polypropylene).
Palm protectors (fig. 1):
Help to protect your wrist during a fall. The support under the hand helps to cushion
the fall. The shape helps to minimise grazes on the fingers and helps you to glide
during a fall.
Elbow protectors and knee protectors (fig. 2 & 3):
Help you glide along the asphalt when falling, so that the fall is cushioned.
HOW TO PUT ON YOUR PROTECTORS
If children use the protectors, adult supervision is recommended during fitting. Al-
ways wear the protectors on the correct side. The left side is marked with an "L", the
right side with an "R".
Palm protectors (fig. 1):
Open the hook and loop fastening and insert your thumb into the hole, so that the
palm of your hand lies on the cushioned back of the shell. The palm protector should
be fitted so that the crash plate protects the palm and wrist. Now tighten up the
straps and fasten the hook and loop fasteners for a comfortable fit.
Elbow protectors and knee protectors (fig. 2 & 3):
Open the hook and loop fastenings and pull on the sock. Fit the elbow protectors so
that the point of the elbow is fitted snugly into the centre of the elbow protector. And
ensure that the knee protectors are placed symmetrically over the kneecap. Fix the
straps and hook and loop fasteners so that the protectors are secure.

MAINTENANCE AND STORAGE

Use a dry or damp cloth only to clean the product; do not use special cleaning agents!
Check the product for damage or traces of wear and tear before and after each use. Do
not make any structural changes. For your own safety, please use original spare parts
only. These can be sourced from HUDORA. If parts become damaged or if sharp edges
or corners should develop, the product may not be used any more. If in any doubt,
please contact our service team (http://www.hudora.de/). Store the product in a safe
place where it is protected from the elements, cannot be damaged, and cannot injure
anyone.
Do not wash! Do not use strong cleaners or detergents! Do not iron! Do not tumble
dry! Do not bleach!
Always clean with a damp cloth and water only. Use of chemical and cleaning sol-
vents, paints and abrasive can cause unseen damage to the protectors and reduce
their ability of protection. Use clear water only. If your protectors are very dirty try
to clean them gently with luke warm water and a brush. Rinse the protectors with
clear water. Do not dry the protectors on a heating. After use you should try to air your
protectors in a room with good air circulation. Never leave your protectors exposed to
direct sunlight or heat. Elevated temperature beyond 40° C would dangerously reduce
the performance of the protectors.

DISPOSAL ADVICE

At the end of the product's life, please dispose of it at an appropriate collection point
provided in your area. Local waste management companies will be able to answer
your questions on this.
SERVICE
We make every effort to deliver faultless products. If faults do arise however, we put
just as much effort into rectifying them. You can find numerous information on the
product, replacement parts, solutions to problems and lost assembly manuals at
http://www.hudora.de.
All images are examples of the design.
5/16