Wohler Smart Connect SC 660 Bedienungsanleitung Seite 49

Fig. 8: Pre-settings pressure test on
water pipes with water
Fig. 9: Display of the pressure curve
during the measurement
Pressure tests on water pipes
Connect a temperature measuring clamp to
•
the Wöhler SC 660 and measure the tempera-
ture of the water pipe.
• Tap on the temperature value "Media temper-
ature" in the app and then enter the measured
temperature as the media temperature in the
app.
• Tap on the blue field "Ambient temperature" to
accept the measured temperature value or tap
on the field of the temperature value to enter
it.
• Enter the desired test pressure, stabilization
time and measurement time if you want to
change the pre-set values.
• Tap the icon for zeroing the pressure if you
want to zero the pressure sensor.
Tap on "Start measurement".
•
• Apply the desired test pressure to the water
pipe.
• The stabilisation phase follows.
After the stabilisation phase, the measurement
•
starts automatically. During the measurement,
the pressure curve can be followed in a graph.
EN
49