IKEA GRUNDAD AA-2198278-4 Bedienungsanleitung Seite 17

ENGLISH
What to do if...
Problem
You cannot switch on the
appliance or operate it.
The display keeps switch‐
ing between two power
settings.
Residual heat indicator is
not displaying anything.
There is no signal when
you touch panel symbols.
and a number come on.
If there is a fault, try to resolve it by following
the troubleshooting guidelines.
If the problem cannot be resolved, contact
your IKEA store or the After Sales Service.
You can find a full list of IKEA appointed
contacts at the end of this user manual.
Possible cause
The appliance is not connec‐
ted to an electrical supply or
it is connected incorrectly.
More than 10 seconds
passed since you switched
on the appliance.
Child Lock or Lock is on
Several symbols on the con‐
trol panel were touched at
the same time.
There is water or fat stains
on the control panel.
Power exchange function is
reducing the power of this
cooking zone.
The cooking zone was only
on for a short time and is
therefore not hot.
The signals are deactivated.
There is an error in the hob.
Remedy
Check if the appliance is cor‐
rectly connected to the electri‐
cal supply. Ensure a correct in‐
stallation by calling an author‐
ised installer.
Switch on the appliance again.
Deactivate Child Lock. Refer to "
.
Child Lock" or " Lock".
Touch only one symbol at a
time.
Clean the control panel and
wait for a few seconds before
switching on again.
Refer to " Power exchange
function".
If the cooking zone is supposed
to be hot, call the After Sales
Service.
Activate the signals. Refer to
"OffSound Control".
Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If
on again, speak to an author‐
ised installer.
If you operated the appliance
wrongly, or the installation was
not carried out by an authorised
installer, the visit from the After
Sales Service technician or dealer
may not take place free of charge,
even during the warranty period.
17
comes