Handle Adjustment; Installation Without Base - Nuna Pipa Bedienungsanleitung

All manuals and user guides at all-guides.com
Handle
adjustment
1 The handle of the infant car seat can be adjusted to 3
positions.
Baby chair position.
Rocking position.
Position for car, hand or stroller transportation.
2 To adjust the handle positon, squeeze handle buttons on
both sides to release it.
3 Rotate handle until it clicks into any of the 3 positions.
Installation
without base
1 Place the infant car seat onto the vehicle seat where you
wish to put it. Pull the vehicle safety belt out and lock it into
the vehicle buckle, sliding the vehicle lap belt into the side
guides of the infant car seat.
2 Slide diagonal belt into the rear guide.
3 Pull the vehicle shoulder belt to fasten the infant car seat
tightly and securely.
4 Level line on carrier must be level to the ground when the car
seat is installed.
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the infant car seat, always check that the
vehicle belts are routed correctly and securely fastened
into the vehicle buckle.
25
(12) -1
(12) -2
(13) -1
(14)
(16)
(30)
(17)
(12) -3
(13) -2
(15)