Securing Child - Nuna Pipa Bedienungsanleitung

All manuals and user guides at all-guides.com
The completely assembled base is shown as
The ISOFIX connectors must be attached and locked
onto the ISOFIX anchor points.
The load leg must be installed correctly with green
indicator.
6 Please refer to step 5, 6 in section 'a. Installation with
3-point-belt' to use the infant car seat.
7 To remove the base, pull the base backwards while pressing
the buttons on the ISOFIX connectors.
Securing
child
Foam inside infant insert is present to ensure that harness
fits child properly. Infant insert must be used for children 0-6
months.
After the child is placed into the seat, check whether the
Shoulder Harness Straps are at proper height.
1 While pressing the adjustment button located at the front of
the infant car seat, pull completely the two Shoulder Harness
Straps of the infant car seat.
2 Unlock the buckle of the harnesses by pressing the red
(31)
button.
3 Place the child into the infant car seat and lock the buckle.
(32)
Please refer to.
4 Tighten the shoulder harness straps by pulling the
adjustment webbing.
Make sure the space between the child and the Shoulder
Harness Straps is about the thickness of one hand.
(28) -2
(30)
(33)
(34)
(28)
(28) -1
(29)
28