Installation With Base; Installation With 3-Point-Belt - Nuna Pipa Bedienungsanleitung

All manuals and user guides at all-guides.com
Installation
with base
This base is only to be used with certain infant car seats.
A proper installation can be done either with the 3-point-belt
or ISOFIX system.
A simultaneous use of both systems is not permitted.

Installation with 3-point-belt

1 Unfold the load leg from storage compartment.
2 After placing the base on the vehicle seat, squeeze load leg
adjust button to extend the load leg to floor
load leg indicator shows green means it is installed
correctly, red means it is installed incorrectly.
The load leg has 12 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing down on
the front of the base.
3 Open the lock-off and route the vehicle safety belt through
(20) -1
the belt path
close the lock-off.
4 Tighten the vehicle safety belt as much as possible while
pushing down on the base, and check it is not loose or
twisted.
Check that the safety belt does not move by pulling
and pushing hard on base. If belt loosens or
lengthens, repeat procedure.
The installed base is shown as Fig.
Please ensure that there is no gap between the seat and the
bottom of the base.
, and lock it into the buckle
(20) -3
(21)
(18)
(19) -1
, the
(19) -2
(20) -2
,
26