Handle Adjustment; Installation Without Base; Installation With Base; Installation With 3-Point-Belt - Nuna Pipa Gebrauchsanweisung

Handle
adjustment
1 The handle of the infant car seat can be adjusted to 3
positions.
(12) -1
Baby chair position.
(12) -2
Rocking position.
Position for car, hand or stroller transportation.
2 To adjust the handle positon, squeeze handle buttons on
(13) -1
both sides to release it.
3 Rotate handle until it clicks into any of the 3 positions.
Installation
without base
1 Place the infant car seat onto the vehicle seat where you
wish to put it. Pull the vehicle safety belt out and lock it into
the vehicle buckle, sliding the vehicle lap belt into the side
guides of the infant car seat.
2 Slide diagonal belt into the rear guide.
3 Pull the vehicle shoulder belt to fasten the infant car seat
(16)
tightly and securely.
4 Level line on carrier must be level to the ground when the car
(30)
seat is installed.
Tension the vehicle safety belt as much as possible,
checking that it is not loose or twisted.
After installing the infant car seat, always check that the
vehicle belts are routed correctly and securely fastened
into the vehicle buckle.
25
(12) -3
(13) -2
(14)
(15)
(17)
Installation
with base
This base is only to be used with certain infant car seats.
A proper installation can be done either with the 3-point-belt
or ISOFIX system.
A simultaneous use of both systems is not permitted.

Installation with 3-point-belt

1 Unfold the load leg from storage compartment.
2 After placing the base on the vehicle seat, squeeze load leg
adjust button to extend the load leg to floor
load leg indicator shows green means it is installed
correctly, red means it is installed incorrectly.
The load leg has 24 positions. When the load leg
indicator shows red this means the load leg is in the
wrong position.
Make sure the load leg is secure by pressing down on
the front of the base.
3 Open the lock-off and route the vehicle safety belt through
(20) -1
the belt path , and lock it into the buckle
(20) -3
close the lock-off.
4 Tighten the vehicle safety belt as much as possible while
pushing down on the base, and check it is not loose or twisted.
Check that the safety belt does not move by pulling
and pushing hard on base. If belt loosens or
lengthens, repeat procedure.
The installed base is shown as Fig.
Please ensure that there is no gap between the seat and the
bottom of the base.
(18)
(19) -1
, the
(19) -2
(20) -2
,
(21)
26