Product Set Up; Installation Concerns; Product Use; Height Adjustment - Nuna todl next Bedienungsanleitung

Product Set Up

Installation Concerns

This enhanced child restraint system is only suitable for vehicle seats
equipped with ISOFIX anchorage bars. (1)
DO NOT use the rearward facing enhanced child restraint system in seating
positions where there is an active frontal airbag installed. (2) Death or
serious injury may occur. Please reference vehicle owner's manual for more
information.
DO NOT install this enhanced child restraint system on vehicle seats that
face sideways or rearward with respect to the moving direction of the vehicle.
Please refer to your vehicle owner's manual for recommended or suggested
installation positions. (3)
It is recommended to install this enhanced child restraint on the rear vehicle
seat. (4)
DO NOT install this enhanced child restraint system on movable vehicle
seats.

Product Use

Base Installation
1
- Attach the ISOFIX guides to the vehicle's ISOFIX anchor bars (see vehicle
owner's manual). (5) The ISOFIX guides can protect the surface of the
vehicle seat from being torn. They can also guide the ISOFIX connectors.
2
- Unfold the load leg from storage compartment. (6)
3
- Extend the ISOFIX connectors by pressing the ISOFIX adjustment button
while pulling on the connector. (7)
4
- Press the ISOFIX adjustment button to adjust the ISOFIX connectors.
Line up the ISOFIX connectors with the ISOFIX guides, and then click
both ISOFIX connectors into the ISOFIX anchor bars. (8)
Make sure that both ISOFIX connectors are securely attached to the
vehicle's ISOFIX anchor bars. There should be two audible clicks and the
colors of the indicators on both ISOFIX connectors should be completely
green. (8)-1
Check to make sure the base is securely installed by pulling on both
ISOFIX connectors.
9 TODL next instruction
5
- After placing the base on the vehicle seat, extend the load leg to floor (9).
When the load leg is installed correctly, the load leg indicator will show
green. Red will be shown when installed incorrectly. (9)-2
The load leg has multiple positions. When the load leg indicator shows
red this means the load leg is in the wrong position.
Make sure the load leg is in full contact with the vehicle floor pan.
Squeeze the load leg adjustment button, then shorten the load leg
upwards. (9)-1
The completely assembled base is shown as (10).
The ISOFIX connectors must be attached and locked onto the ISOFIX
anchor bars. (10)-1
The load leg must be installed correctly with green indicator. (10)-2
6
- To remove the base, press the secondary lock button (11)-1 first followed
by the button (11)-2 on the ISOFIX connectors before removing the base
from the vehicle seat. (11)
7
- For transporting, press ISOFIX Adjustment button and move the ISOFIX
connectors back into the storage position. (12)
Use Side Impact Protection
1
- The enhanced child restraint is delivered with removable side impact
protection pod. This side impact protection pod MUST be used on the
door side of the vehicle. Installation shown in (13).
2
- Press the release button to remove side impact protection pod. (14)

Height Adjustment

for Head Support and Shoulder Harnesses
Please adjust the head support and check if the shoulder harnesses are at the
correct height according to (15)(16)(17)(18).
When used in rearward facing mode, the shoulder harness height must
be even with or just below the top of child's shoulders. (15)
When used in forward facing mode, the shoulder harness height must be
even with the top of child's shoulders. (16)
Pull the head support adjustment lever (17), meanwhile pull up or down the
head support until it snaps into one of the 6 positions. The head support
positions are shown as (18).
TODL next instruction 10