Introduction; Technical Data; Conformity - GREISING Clean Marker Brush-IT Bedienungsanleitung

Further information
• Should skin or clothes come into contact with chemicals, they should be
washed immediately with plenty of water.
• Do not eat or drink at the workplace.
• Always wash your hands before taking a break.
• Keep the equipment and chemicals away from children.
1.3.7 Maintenance and servicing, repairing faults
The prescribed maintenance work and inspections are to be carried out
on schedule. Before beginning maintenance work, inspection or repairs,
switch the unit off and secure by „pulling the plug".
1.3.8 Constructional changes on unit
Without the prior consent of the manufacturer, no alterations, additions or
removals of any sort may be made on the unit. Only spare or replacement
parts originating from the manufacturer or his authorised dealer may be
used.
1.3.9 Emission
Electrolyte may vaporise during etching and cleaning. These vapours
should not be inhaled. Provide fresh air circulation in your place of work.
2

INTRODUCTION

2.1 TECHNICAL DATA

General data
Size L x H x W
[mm]
Weight, ca. [kg]
Power
Protection class

2.2 CONFORMITY

The unit fulfils the following regulations and standards:
• EMV - Regulations 2004/108/EG
• Low Voltage Regulations 2006/95/EG
The CE - label is on the front of the unit.
The type plate with the special unit number is attached to the rear.
Operation Manual Clean Marker Brush − Page 25
Brush-IT-800 Brush-IT-1500
Brush-IT-P 1500
180 x 320 x 430 180 x 320 x 430
6,9 6,9
800 Watt 1500 Watt
IP 23 IP 23
Brush-IT-2500 Brush-IT-3500
Brush-IT-P 2500 Brush-IT-P 3500
180 x 320 x 430 180 x 320 x 430
6,9 6,9
2500 Watt 3500 Watt
IP 23 IP 23
- -
25