GREISING Clean Marker Brush-IT Bedienungsanleitung Seite 30

INSTRUCTIONS FOR USE
• push the 3 - pole plug in the driving power connection
• unwind as much as you need of the acid tube from the drum
Liquid will only be fed when the button on the cleaning head is pressed.
When pumping, open the acid container a little so that negative pressure
cannot build up when the liquid is sucked up and damage the pump. On
all Clean Markers equipped with pump the electrolyte is sucked up directly
from an external 5 / 10 litre cannister, a bottle or a wide - necked container.
The acid tubing must therefore be hung into the electrolyte container.
5.1.2 Settings at the control dial
(see page 9, item
Control range: Cleaning:
After starting up, as explaned at 4.1.1, conect the included cleaning brush
(see figure on the left).
Now you can clean discoloration from welding seams in the control
range shown above. Therefore use the electrolytes due to the degree of
discoloration:
Greinox Clean, Greinox Polish, Greinox Fix or Greinox TF
Control range: Polishing
After starting up, as explaned at 4.1.1, conect the included polishing tool
(see figure on the left). In the control range (shown above) you can now
polish small areas.
Therefore use the electrolytes Greinox Fix or Greinox Polish.
Marking:
After starting up, as explaned at 4.1.2, connect the included marking tool
(see figure on the left).
Therefore use the marking electrolytes GE08, GE21, GE B3 or GE BW2.
While marking, the power control dial
tightly
into the electrolyte container
)
4
and screw it up
11
4
is out of function.
Operation Manual Clean Marker Brush − Page 30
and tip it
13