Controls And Settings; Direct Controls - urmet 3000/321 Bedienungsanleitung

2

CONTROLS AND SETTINGS

1 2 3 4 5
2.1

DIRECT CONTROLS

POWER CONNECTOR
Connect the supplied power cavle to the mains connector.
ON/OFF BUTTON [5]
This is used to switch the monitor on and off. The green LED, under the front panel, lights up when the monitor is on or in
standby condition.
IMPORTANT NOTE
➢
If the following message appears on the monitor after pressing the button (5):
NO SIGNAL
It means that a not connected video signal has been selected as input.
SELECTION BUTTONS [2-3]
They allow to select the menu options inside the OSD Menu.
VOLUME BUTTONS [2-3] AND CONFIRM [4]
They allow to change the volume (5 button increases the volume – 4 button decreases the volume).
4 button also allows to confirm each setting.
MENU BUTTON [4] AND CONFIRM
This is used to access and quit the OSD (On-Screen Display) Menu and to confirm the selected settings
VIDEO INPUT SELECTION BUTTON [1]
To select the desired signal (""VGA", "HDMI") press the button (1) and select the desired item with the buttons (2-3)
"DOWN" and "UP". Press the button "4" to confirm.
HDMI INPUT
It allows the connection of an HDMI signal and an audio signal, coming from an external source provided with an HDMI
output
VGA INPUT
VGA input.
AUDIO INPUT
Audio input on Jack.connector
DS3000-030A 13