Controls And Settings; Direct Controls - urmet 3000/332 Bedienungsanleitung

2

CONTROLS AND SETTINGS

1 2 3 4 5
2.1

DIRECT CONTROLS

POWER CONNECTOR
Connect the supplied power cavle to the mains connector.
ON/OFF BUTTON [5]
This is used to switch the monitor on and off. The green LED, under the front panel, lights up when the monitor is on or in
standby condition.
IMPORTANT NOTE
➢
If the following message appears on the monitor after pressing the button (5):
NO SIGNAL
It means that a not connected video signal has been selected as input.
SELECTION BUTTONS [2-3]
They allow to select the menu options inside the OSD Menu.
VOLUME BUTTONS [2-3] AND CONFIRM [4]
They allow to change the volume (5 button increases the volume – 4 button decreases the volume).
4 button also allows to confirm each setting.
MENU BUTTON [4] AND CONFIRM
This is used to access and quit the OSD (On-Screen Display) Menu and to confirm the selected settings
VIDEO INPUT SELECTION BUTTON [1]
To select the desired signal (""VGA", "HDMI") press the button (1) and select the desired item with the buttons (2-3)
"DOWN" and "UP". Press the button "4" to confirm.
RS232 PORT
Not used
AUDIO INPUT
Audio input on Jack connector
VGA INPUT
VGA input.
DS3000-057 13