PeakTech 5306 Bedienungsanleitung Seite 13

Cleaning the cabinet
Clean only with a damp soft cloth and a commercially available mild
household cleanser. Ensure that no water gets inside the equipment
to prevent possible shorts and damage to the equipment.
2. Introduction
The PeakTech 5306 is used to measure the pH, conductivity and
temperature of various liquids and liquids. With the removable probe,
it is possible after the respective measurement to thoroughly free the
device and the probe from residues of the liquid and to clean them.
An calibration can be carried out via two potentiometers using the
attached screwdriver.
To protect the measuring electrode, a protective cap is attached to
the end of the P 5306 (this is removed during the measurement).
* Digital pH meter with illuminated display
Conductivity measurement in µS/cm
*
Conductivity is shown as µS x10
*
Liquid temperature measurement (°C/°F)
*
Multi-Line, 3½-digit LC Display
*
* Can be calibrated with 2 calibration points
Exchangable measuring electrode (dry stored)
*
* Waterproofed case
* Electrode protective cap
-13-