Network Interface - Balluff BNI PNT-565-W01-K079 Montageanleitung

BNI PNT-565-W01-K079

Network interface

The CE Mark verifies
that our products meet the requirements
of the current EU Directive.
About this guide
This guide provides important information for the
installation and connection of the Profinet IO-Link Wireless
Master.
It applies to the following models:
BNI PNT-565-W01-K079
–
Intended use
The PROFINET IO-Link Wireless Master serves as a
separate I/O module (in combination with IOLW Hub
BNI IOW-302-W01-K080) and IO-Link Block (in
combination with IOLW Bridge BNI IOW-560-W01-K022)
for connection to a PROFINET fieldbus and is intended for
use in industrial applications. The use of standardized
IO-Link wireless technology enables wireless
communication with the connected subscribers.
Flawless function in accordance with the specifications in
the technical data is ensured only when using suitable
original Balluff accessories. Use of any other components
will void the warranty.
The module may only be operated with an approved
power supply. Only approved lines may be connected.
Non-approved use is not permitted and will result in the
loss of warranty and liability claims against the
manufacturer.
Reasonably foreseeable misuse
The product is not intended for the following applications
and areas and may not be used there:
– In safety-oriented applications in which personal safety
depends on the device function
– In explosive atmospheres
– in domestic settings (product is class A (EMC limit) for
the industrial sector)
130
1 english
Other applicable documents
A comprehensive user's guide and additional information
about this product can be found at www.balluff.com on
the product page.
Safety notes
Activities such as installation, connection and
commissioning may only be carried out by qualified
personnel.
Qualified personnel are persons whose technical
training, knowledge and experience as well as knowledge
of the relevant regulations allow them to assess the work
assigned to them, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed.
In particular, the operator must take steps to ensure that a
defect in the product will not result in hazards to persons
or equipment.
The product must not be opened, modified or changed. If
defects and unresolvable faults occur in the product, take
it out of service and secure against unauthorized use.
The BNI modules generally have good chemical and oil
resistance. When used in aggressive media (e.g.
chemicals, oils, lubricants and coolants) in high
concentrations (e.g. due to low water content), the material
resistance must be checked in advance for the specific
application. In the event of failure or damage to the BNI
modules due to aggressive media, claims for defects are
ruled out.
Dimensions
50.5
21
Configuration key inoperative
M4 (4×)
2 Nm
M5 (2×)
2 Nm
FE
M4
37.5
1,5 Nm
75