Useful Information - Honda HRD536 Betriebsanleitung

1. Drain the fuel tank and the
carburetor into a suitable
receptacle [2]:
a. Place the throttle control
lever [4] in "FAST"
position [A] and open the
fuel shut-off valve.
b. Loosen the carburetor
drain bolt [1] by turning 1
to 2 turns
counterclockwise.
c. After all fuel has drained,
tighten the carburetor
drain bolt securely, close
the fuel shut-off valve [3].
2. Change the engine oil (see
page 9).
3. Pull the starter slowly until a
resistance is felt. This closes
the valves and protects them
from dust and corrosion.
4. Coat all surfaces liable to
rust with a thin film of oil.
Cover the lawnmower and
store it on a flat surface in a
dry, dust free place. Do not
use a plastic cover since this retains dampness.
NOTE: If the lawnmower is to be stored for a period of more than 3
months, remove the spark plug and pour 5 to 10 cc of clean engine
oil into the cylinder; then pull the starter slowly 2 or 3 times to spread
the oil. Do not leave the lawnmower lying on its side over long
periods. This may cause difficult starting and gear oil leaks.
FUEL STORAGE
NOTE:
• Petrol will oxidize and deteriorate in storage.
Old petrol will cause hard starting, and it leaves gum deposits that
clog the fuel system. If the petrol in your engine deteriorates
during storage, you may need to have the carburetor and other
fuel system components serviced or replaced.
• Ensure that you use
containers or drums
specifically designed for
hydrocarbons [5]. This will
prevent polluting the fuel
through the dissolution of
the container walls, which
will lead to poor
functioning of the engine.
• Store the fuel in a dark
place, in a room at
constant temperature (avoid garden sheds).
• The warranty does not cover a blocked carburetor or valves
jammed by old or polluted fuel.
• The quality of unleaded petrol deteriorate very quickly (2 to
3 weeks in some cases). Do not use fuel more than 1 month old.
Store the absolute minimum required for your monthly
consumption.
14 EN
[A]
[4]
[2]
[1]
[3]
[5]
USING THE LAWNMOWER AFTER A STORAGE
PERIOD
1. Remove the spark plug, check that it is clean and that the
electrode gap is correct. Pull the starter several times
page 10).
2. We recommend that the spark plug be screwed down as far as
possible by hand until finger tight; then use a wrench to tighten
it by an extra 1/8 or 1/4 turn.
3. Check the level and condition of the engine oil
4. Fill the fuel tank and start the engine.
NOTE: If the cylinder has been coated with oil, the engine will
smoke on start-up. This is normal.

USEFUL INFORMATION

FIND AN AUTHORIZED DEALER
Please refer to the European Internet site:
http://www.honda-eu.com
[6]
[14]
[12]
CURRENT PARTS, OPTIONAL ATTACHMENT AND
CONSUMABLES
To buy one of the original parts listed below, or any other part,
please contact an authorized Honda dealer.
HRD536
HXEH
Current parts
81320-
[6] Grass catcher
VF1-023
[7] Rear wheel 42710-VF1-000ZA
[8] Air filter
[9] Front wheel 44710-VF0-000ZB
[10] Spark plug
[11] Cutting means 72511-VG0-C50
Recoil
[12]
starter
Optional part
[13] Mulching kit 06762-VF1-C51
Consumables
[14] Engine oil
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
your lawnmowers' model and type.
(see page
[7] [8]
[13] [11]
HRH536
QXEH HXEH QXEH
81320- Grass catcher only
81320-VG0-013
VF0-023 (without frame)
42810-VB5-F43ZB (except QXEH)
17218-888-003 Filter paper
42710-VB5-F41ZB
98079-55846 BPR5ES (NGK)
Requires use of a
72511-VF0-K60
dynamometric key
Ask your servicing
28462-Z1V-801 dealer to replace
these
1 upper cutting
means
06762-VG0-B51
1 mulching plug,
1 owner's manual
Oil for 4-stroke
08221-888-061HE
SAE10W30, 0.6 ℓ engines
SAFETY
(see
7).
[9]
[10]
A2 C5
C23 D3