Useful Information - Honda HRD536HXE Betriebsanleitung

1. Drain the fuel tank and the
carburetor into a suitable
receptacle [2].
a. Place the throttle control
lever [4] in "FAST"
position [A] and open the
fuel shut-off valve.
b. Remove drain plug [1] to
drain carburetor and fuel
tank.
c. Refit the drain plug and
close the fuel shut-off
valve [3].
2. Change the engine oil
(see page 8).
3. Pull the starter slowly until a
resistance is felt. This closes
the valves and protects them
from dust and corrosion.
4. Coat all surfaces liable to rust
with a thin film of oil. Cover the
mower and store it on a flat
surface in a dry, dust free place.
Do not use a plastic cover since
this retains dampness.
NOTE: If the mower is to be stored for a period of more than 3
months, remove the spark plug and pour 5 to 10 cc of clean engine
oil into the cylinder ; then pull the starter slowly two or three times to
spread the oil. Do not leave the mower lying on its side over long
periods. This may cause difficult starting and gear oil leaks.
FUEL STORAGE
NOTE:
• Petrol will oxidize and deteriorate in storage.
Old petrol will cause hard starting, and it leaves gum deposits that
clog the fuel system. If the petrol in your engine deteriorates
during storage, you may need to have the carburetor and other
fuel system components serviced or replaced.
• Ensure that you use
containers or drums
specifically designed for
hydrocarbons [5]. This will
prevent polluting the fuel
through the dissolution of
the container walls, which
will lead to poor functioning
of the engine.
• Store the fuel in a dark
place, in a room at constant
temperature (avoid garden sheds).
• The warranty does not cover a blocked carburetor or valves
jammed by old or polluted fuel.
• The quality of unleaded petrol alters very quickly (2 to 3 weeks in
some cases). Do not use fuel more than 1 month old. Store the
absolute minimum required for your monthly consumption.
[A]
[4]
[2]
[1]
[3]
[5]
USING THE MOWER AFTER A STORAGE PERIOD
1. Remove the spark plug, check that it is clean and that the
electrode gap is correct. Pull the starter several times
(see page 9).
2. We recommend that the spark plug be screwed down as far as
possible by hand until finger tight ; then use a plug spanner to
tighten it by an extra 1/8 or 1/4 turn.
3. Check the level and condition of the engine oil
4. Fill the fuel tank and start the engine.
NOTE: If the cylinder has been coated with oil, the engine will
smoke on start-up. This is normal.

USEFUL INFORMATION

FIND AN APPROVED DEALER
Please refer to the European Internet site:
http://www.honda-eu.com
[6]
[12] [14]
CURRENT PARTS, OPTIONAL ACCESSORIES
AND CONSUMABLES
To buy one of the original parts listed below, or any other part,
please contact an approved Honda reseller.
HRD536
HXE
Current parts
81320-
[6]
Grass bag
VF1-023 VF0-023
[7]
Rear wheel 42710-VF1-000ZA
[8]
Air filter
[9]
Front wheel 44710-VF0-000ZB
[10]
Spark plug
[11]
Blade 72511-VG0-C50
Recoil
[12]
starter
Optional part
[13]
Mulching kit 06762-VF1-C51
Consumables
[14]
Engine oil
For your safety, it is strictly prohibited to
install any other attachment than the ones
listed above and especially designed for
your lawn mower model and type.
(see page
[7]
[8]
[13] [11]
HRH536
QXE HXE QXE
81320-
81320-VG0-013
42810-VB5-F43ZB
17218-888-003
42710-VB5-F41ZB
98079-55846
72511-VF0-K60
28462-Z1V-801
06762-VG0-B51
08221-888-061HE
SAE 10W30, 0.6 
SAFETY
6).
[9]
[10]
Bag only
(without frame)
(except QXE)
Filter paper
BPR5ES (NGK)
Requires use of a
dynamometric key
Ask your Honda
dealer to replace
these
1 upper blade
1 plug
1 owner's manual
Oil for 4-stroke
engines
A2 C4
C22 D3
13 EN