Automatic Station Scan; Manual Station Scan; Scan Settings; Audio Settings - TechniSat TECHNIRADIO 3 Bedienungsanleitung

8.3 Automatic station scan

> Hold down the <Tune or Tune> buttons for longer (2 to 3 sec.) in order to
automatically search for the next station with sufficient signal intensity.
> Alternatively, you can press the Select button.
If an FM station with sufficient signal strength is found, the scan stops and the
station is played. If an RDS station is received, the station name, and possibly the
radio text, appear.
Please use the manual station scan for setting weaker stations.

8.4 Manual station scan

> Press the <Tune or Tune> buttons repeatedly to set the desired stations or frequency.
The display shows the frequency in increments of 0.05 MHz.

8.5 Scan settings

In this menu item it is possible to set the sensitivity of the scan.
> Hold down the Menu button, use the <Tune or Tune> buttons to select the [Scan
settings] item and press the Select button.
102
> Select whether the scan should only stop for stations with a strong signal
[Strong Stations Only] or for all stations (including stations with a weak signal)
[All Stations].
With the All Stations setting, the scan stops automatically upon detecting each
available station. This can result in weak stations being played with background
noise.

8.6 Audio settings

> Hold down the Menu button and use the <Tune or Tune> buttons to select the
[Audio settings] item.
> Press the Select button.
> Using the < Tune or Tune> buttons, select the [Stereo available] or [Mono only]
item in order to play back in stereo (only available via headphones) or only in
mono when the FM reception is weak.
> Confirm by pressing the Select button.
DE
EN
DA
NL
103