Deleting Inactive Stations; Switching On Fm Radio Mode; Fm Reception With Rds Information - TechniSat TECHNIRADIO 3 Bedienungsanleitung

> Select the compression rate with <Tune or Tune>:
DRC high - high compression
DRC low - low compression
DRC off - compression switched off
> Confirm by pressing the Select button.

7.2.9 Deleting inactive stations

This menu item is for removing old stations and those no longer being received from
the station list.
Inactive stations are marked with a question mark in the station list.
> Hold down the Menu button and use the <Tune or Tune> buttons to select the
[Delete inactive stations] item.
> Press the Select button.
This is followed by the [Delete?] prompt asking if the inactive stations are to be
deleted.
> Using the <Tune or Tune> buttons, select the [Yes] item and confirm by pressing
the Select button.
100
8 FM mode

8.1 Switching on FM radio mode

> Switch to FM mode by briefly pressing the
> [FM] is shown on the display.
When you switch on the radio for the first time, the frequency is set to 87.5 MHz.
If you have already set or saved a station, the radio plays the last station set.
In the case of RDS stations, the station name is displayed.
Align the telescopic antenna to improve reception (Section 5.3.3).

8.2 FM reception with RDS information

RDS is a procedure for broadcasting additional information via FM stations. Broadcasters
with RDS broadcast their station name or the programme type, for example. This is
shown in the display. The device can show the RDS information RT (Radio text), PS
(Station name), PTY (Programme type).
/Mode button.
101
DE
EN
DA
NL