Measurements Display Area; Single-Phase Connection - Riello 5000VA Installations- Und Bedienungsanleitung

Measurements display area

The most important measurements regarding the UPS may be posted on the display in sequence.
When the UPS is switched on, the display shows a reading of the mains voltage value.
To change to a different display, press the "SEL / SET" button repeatedly until the desired quantity appears.
If there is a failure / alarm (FAULT) or a block (LOCK), the display will automatically show the type and
code of the corresponding alarm.

Single-phase connection

Some examples are shown below:
(1)
GRAPHIC EXAMPLE
Voltage output from the
Output voltage frequency
Residual battery back up
Percentage of battery
(1)
The values shown in the images in the table are purely indicative.
(2)
The FAULT/LOCK codes can only be displayed if they are active (i.e., if there is a fault/alarm or a lock).
All manuals and user guides at all-guides.com
DESCRIPTION
Mains voltage
Mains frequency
UPS
time
charge
(1)
GRAPHIC EXAMPLE
Total battery voltage
Percentage of the applied
Current absorbed by the
Temperature of the
cooling system for the
UPS internal electronics
Fault/Alarm
corresponding code is
corresponding code is
U
SE
DESCRIPTION
load
load
(2)
: the
displayed
(2)
Lock : the
displayed
51