Display Panel Indications; Ups Status Indicators - Riello 5000VA Installations- Und Bedienungsanleitung

U
SE
D
ISPLAY PANEL INDICATIONS
This section describes in detail all the information that can be shown on the LCD display.
In order to make it clearer, all the information displayed can be divided into three main groups:

UPS status indicators

Measurements display area
Configuration area
UPS status indicators
ICON
50
All manuals and user guides at all-guides.com
STATUS
Constant
Flashing
Constant
Constant
The UPS is operating from the mains, but the output voltage is not
Flashing
The UPS is operating from the battery. When it is in this state the UPS
Constant
emits an acoustic signal (beep) at regular intervals of 4 sec.
End of discharge prealarm. Indicates that the battery back up time is
Flashing coming to an end. In this condition the UPS emits a beep at regular
Indicates that the loads connected to the UPS are powered from the
Constant
Dynamic Indicates the estimated percentage of back-up time
Indicates the % of load applied to the UPS with respect to the nominal
Dynamic
Flashing
Indicates that the timer is activated (programmed start-up or shutdown).
Constant
The timer can be activated/deactivated via the software provided
1 minute to go before the UPS starts up or 3 minutes before it shuts
Flashing
DESCRIPTION
Indicates a fault
The UPS is in stand-by state
Indicates regular operation
The UPS is operating from the mains
synchronized with the mains voltage
intervals of 1 sec.
bypass
value
A maintenance operation is required
down