SCOPREGA TURBO MAX 12V Anleitung Seite 8

8. USE AND OPERATION
8.1 ACCESSORIES AND POWER CABLES
1. TURBO MAX 12V and TURBO MAX 24V/S versions: the inflation hose, adapters and
cable with clamps are located inside the carry bag.
2. TURBO MAX KIT 12V and TURBO MAX KIT 24V-EV versions: as they are intended for a
permanent installation, brackets and retaining screws are provided. The power cable is 50 cm
long and is wired with a 100 A connector.
The inflation hose and valve fittings are supplied only upon request.
Adapters for bayonet valves are available as an optional feature (see catalogue).
8.2 CONNECTING THE ACCESSORIES
1. Choose the most suitable adapter for the valve on the object to be inflated.
During inflation/deflation, the valve should be kept open by a suitable adapter.
2. Make sure that the main switch is set to OFF.
3. Connect the inflation hose according to the operation to be performed:
to inflate (connect to the OUT outlet), to deflate (connect to the IN outlet).
4. Insert the adapter into the valve of the object to be inflated/deflated.
8.3 TURNING ON THE INFLATOR
1. Connect clamps to battery or, for KIT versions, make sure that the power connectors are
properly assembled
2. Always stretch the electric cable.
3. Set the desired inflation pressure (value between 175 and 250 mbar).
4. Set the switch to ON. LED B starts flashing, indicating battery status (refer to paragraph
Inflator and Battery Status Monitoring)
5. Press the START switch. LED B shifts from flashing to steady, the colour depends on the
battery status
6. When inflating, the inflator will stop at the set pressure and LED B will resume flashing
7. In the event of an error, the inflator stops as a protective measure. LED A lights up to
indicate the type of problem (refer to paragraph Inflator and Battery Status Monitoring).
Once the problem has been fixed, the inflator should be restarted by pressing START.
8. To deflate, connect the hose to the IN outlet and set the pressure setting knob to 175 mbar.
WARNING
In case crocodile clips are used, make sure of the correct polarity (red clamp connected to
battery positive terminal).
Otherwise the inflator will not start.
14
8.4 ACCESSORY WARNING
The recommended accessories when using the inflator are the original SCOPREGA ones.
The use of any accessory not recommended for this inflator can be dangerous.
9. INFLATOR AND BATTERY STATUS MONITORING
LED A LED B
OFF OFF
Flashing Standby, CHARGED
OFF
GREEN
Flashing
OFF
YELLOW
Flashing RED
OFF
Steady GREEN
OFF
CHARGED battery
Steady YELLOW
OFF
Steady RED
OFF
RED CYCLE END due to
RED
flashing
CYCLE END due to
UNDERVOLTAGE or
Flashing
OVERVOLTAGE
RED
GREEN
permitted limits
Flashing (colour
RED CYCLE END due to
depends on the
flashing OVERTEMPERATURE
battery status)
WARNING
When connecting the power cable to the battery , make sure to avoid short circuits and
possible fire risk
WARNING
Check the voltage. Do not connect the 12V inflator to a 24V battery.
WARNING
Do not leave the inflator running unattended. Overinflating an object could result in
serious injury.
WARNING
Always check the maximum inflation pressure to avoid risks of explosion.
STATUS POSSIBLE SOLUTION
OFF
battery
We recommend you to charge the
Standby
battery before operating.
LOW battery
Standby
Charge the battery
LOW battery
Operating
Operating We recommend you to charge the
LOW battery battery before operating.
Operating
Charge the battery
LOW battery
Charge the battery and then press START
LOW battery
to restart the inflator
Make sure that the battery voltage
complies with the values indicated in
Voltage below
paragraph TECHNICAL FEATURES
Only after the LED indicators have
stopped flashing can the inflator be
restarted by pressing START
15