SCOPREGA TURBO MAX 12V Anleitung Seite 7

M A N U A L O F
SAVE THIS INSTRUCTIONS MANUAL FOR REFERENCE
2. FOREWORD
Dear customer,
congratulations on choosing Scoprega.
We design and manufacture products of the highest quality to meet the needs
of our customers. Scoprega offers the highest quality in service as well. Our
specialised departments provide support and instructions when needed, as well
as comprehensive technical service.
We thank you for your trust.
WARNING
Read these instructions before using the inflator. Failure to follow all the instructions listed
below may result in damage to the product and/or cause serious injury to persons.
3. PRELIMINARY WARNINGS
1. Comply with all instructions in this document.
2. Keep these instructions.
3. Do not block the air vents (SEE FIGURE XX ON PAGE 3).
4. Always protect the power cable.
5. Do not open the inflator. Refer all servicing to qualified service personnel authorised by Scoprega.
Servicing is required when the device is damaged or not working in any way.
6. Do not tamper with the product. Opening the inflator will void its warranty.
7. Provide suitable ventilation
8. Avoid placing objects near the product during operation.
9. Keep this product out of the reach of children.
10. The operating inflator produces vibrations: therefore, we recommend you to use it on the floor, so
as to avoid accidental falls.
4. INTRODUCTION
The TURBO MAX is a high-efficiency portable electric inflator, which stands for reliability and
functionality. The TURBO MAX is equipped with two powerful DC motors that drive two turbines
connected in series, thus allowing any object to be inflated to a pressure between 175 and 250 mbar.
The inflator is equipped with LED indicators checking pump status during operation. The inflator starts
when the ON button is pressed and automatically stops when the set pressure on the knob (2) is
reached. The device stops when the user presses the OFF button.
5. RECOMMENDED USES
Large inflatable objects (rubber dinghies / tents / rafts).
12
I N S T R U C T I O N S
6. TECHNICAL SPECIFICATIONS
VOLTAGE
ITEM
(V)
TURBO MAX 12V 9.5 ÷ 14.5
TURBO MAX 24V/S
19.5 ÷ 28.5
TURBO MAX KIT 12V 9.5 ÷ 14.5
TURBO MAX KIT 24V-EV
19.5 ÷ 28.5
7. GENERAL SAFETY RULES
1. ALWAYS TAKE INTO ACCOUNT THE WORKING ENVIRONMENT.
Do not expose the inflator to rain. Do not use in the presence of flammable liquids or gases.
2. AVOID UNINTENTIONAL STARTING.
Do not start the inflator with the inlet in contact with dust or water.
3. PAY ATTENTION.
Pay attention to what you are doing. Use common sense.
4. CHECK THAT THERE ARE NO DAMAGED PARTS.
Before using the inflator, carefully check its outer sides and components.
5. DO NOT OPERATE
portable inflators near flammable liquids or in gaseous or explosive
atmospheres. The inflator motors produce sparks that can release fumes.
6. DO NOT INHALE!
The compressed air coming from the inflator is not clean. Never inhale air from your inflator.
7. WARNING! RISK OF EXPLOSION.
Inflate the unit only complying with the manufacturer's recommendations. Exceeding the pressure
rating could cause the inflator to explode, resulting in personal injury.
8. NEVER LEAVE THE DEVICE UNATTENDED.
Overinflation could result in serious injury and property damage.
9. WARNING! RISK OF UNSAFE OPERATION
Do not modify or attempt to repair the unit. Do not drill into or make any modifications to the inflator
or its accessories. Any modification to the product will void its warranty.
10. Never carry the inflator by the flexible hose or power cable.
LED INDICATORS
The inflator is equipped with two LED indicators
(A and B) that allow the battery status and the
pump temperature to be checked.
LED A indicates the operating errors that
have stopped inflator operating cycle (refer
to paragraph Inflator and Battery Status
Monitoring).
LED B indicates battery charging status
MAX.
POWER
FLOW RATE
PRESSURE CONSUMPTION
(L / minute)
(mbar) (A)
1000 250
70
1000 250
35
1000 250
70
1000 250
35
13