Venga VG RVC 3000 WH Bedienungsanleitung Seite 9

A. Install side brushes
B.
Attach side brushes to the bottom of the
robot by pressing a brush into each slot.
C. Remove the bumper protectors and turn on
the main power switch on the bottom of the
robot.
D. Charge the robot
Place the robot onto the charging dock,
making sure the charging contact pins on
the charging dock match up with those
underneath the robot. If successful, you will
hear 3 tones and the robot will start
charging with a beathing orange light.
E.
F.
Start cleaning
G. Press the power button
the robot.
Press the power button
fully automatic cleaning cycle with the one-
touch control. Plug and play - simple as
that!
To pause the robot, press the
the robot or press the
remote control.
To resume the cleaning cycle, press the
same button again.
To send robot back to the charging dock,
press the button on the robot or on the
remote control.
If you want to simply end the cleaning cycle
and put your robot in standby mode, press
and hold the
indicator light turns off.
once to wake up
again to start a
button on
button on the
button until the robot's
9 VG RVC 3000