Venga VG RVC 3000 WH Bedienungsanleitung Seite 15

TROUBLESHOOTING – ERROR TONE
Your Venga! robot will tell you when something is wrong with a two-tone distress sound. The
indicator will also blink or light up in red. Refer to the chart below to resolve the robot's
problem.
For some errors, rebooting the robot may resolve the problem. To reboot the robot, use the
main power switch on the bottom of the robot. You will hear a tone signifying a successful
reboot.
ROBOT BLINKS AND
INDICATES
BEEP Once
BEEP Twice
Solid red
indicator
light
BEEP Three
times
BEEP Four
Times
BEEP Twice
BEEP Three
times
Breathing
red
indicator
light
BEEP Four
Times
LIKELY CAUSE
The swivel wheel is stuck.
A side brush can't rotate.
The filters are clogged.
The rolling brush can't
rotate.
The bumper is stuck.
The cliff sensors are dirty.
The robot is hanging over
a cliff.
The robot is stuck on a
dark surface.
The robot cannot return
to its charging dock or
starting position.
15
WHAT TO DO
Clean the swivel wheel and
press the power button to
restart the robot.
Clean the side brush and
press the power button to
restart the robot.
Remove and empty the
robot's dust bin. Clean the
robot's filters and briskly tap
the bin to loosen any
remaining trapped debris.
Remove and clean the
robot's rolling brush
and caps.
Check whether the bumper
is flexible.
If the robot is hanging over
a drop edge or is placed on
a dark surface, start it in a
new location. Otherwise,
wipe its cliff sensors with a
dry cloth.
Ensure there are no
obstacles in front of the
charging dock or starting
position. Wipe the charging
contact pins on both the
charging dock and robot
with a clean, dry cloth.
VG RVC 3000