Kinderkraft EVERYDAY Bedienungsanleitung Seite 31

• Check that the pram body or seat unit or car seat attachment
devices are correctly engaged before use.
• This product is not suitable for running or skating.
• The product is designed to transport one child at a time.
• Maximum basket load 5 kg.
• Any load attached to the handle and/or on the back of the backrest and/or on the sides of the vehicle will affect the
stability of the vehicle.
• The maximum permissible weight of a parent's bag suspended on the buggy's handles is 3 kg.
• The maximum load carried in the cup holder must never exceed 0,5 kg.
• Lift the front suspension when going up a curb or step.
• The brakes should be locked when the child is placed in or taken out of the buggy.
• Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or accessories.
• Do not place the product near open flame or other heat sources.
• Do not use with an additional platform.
The following applies to the Pram body:
This product, in the form of a Pram body, is designed for children
who cannot sit unaided, fall over or crawl using hands and knees.
Maximum child weight – up to 9 kg.
WARNING: This product is only suitable for a child who cannot sit
up unaided. Only use on a firm, horizontal level and dry surface.
Do not let other children play unattended near the carry cot. Do
not use if any part of the carry cot is broken, torn or missing.
Before carrying or lifting the base shall be adjusted in the lowest position.
The head of the child in the carry cot should never be lower than the body of the child.
Do not insert an extra mattress apart from that supplied with the product.
The following applies to the pushchair:
WARNING! Always use the restraint system.
The product is intended for children from 0 months old to 22 kg or 4 years whichever come first.
Applies to the Kinderkraft MINK car seat:The Kinderkraft EVERYDAY buggy can be offered in a set with a compatible
Kinderkraft MINK car seat. The product is intended for children from birth to 13 kg. If the seat is used together with the
buggy, it does not replace a cradle or crib. For sleep, place the child in the Pram body, cradle or crib. Use only parts and
accessories supplied or recommended by the manufacturer.
I BUGGY COMPONENTS
1. Frame with a basket
2. Seat (3) with canopy (4)
5. Rear wheel x2
6. Front wheel x2
7. Safety bow
8. Cup holder
9. Mosquito net
II UNFOLDING THE FRAME OF THE BABY STROLLER Place the frame with the basket (1) on a flat surface with the handle
upwards. To unfold the frame, release the locking device on the right-hand side (Fig.A.I) and then lift up the latches on both
sides of the frame simultaneously (Fig.A.II). Hold the frame up until you hear the characteristic locking sound.
III WHEELS ASSEMBLY/DISASSEMBLYInsert the front wheels (6) into the holes in the front of the frame until you hear the
locking sound (Fig.B.I). To remove the wheels, press the front wheel release button (Fig.B.II). The stroller is equipped with a
front wheel swivel system with a locking system for straight maneuvering. To unlock/lock, slide the lock to the left/right
(Fig. B.III) Insert the rear wheels (5) into the holes in the rear frame until it locks, making sure the flat surfaces of the axle
and hole are aligned correctly (Fig. B.IV). To remove the rear wheel, press the release button and pull (Fig.B.V).
10. Rain cover
11. Foot cover
12. Sun cover
13. Nacelle with mattress (14) and foot cover (15)
16. Adapters
31