Surface Mounting - PCE WALLBOX EV11 Montage- Und Bedienungsanleitung

6.3 Surface mounting

NOTE
Check the charging station for any damage after
unpacking.
NOTE
For assembly and installation of the charging
station, the respective national regulations must
be observed.
NOTE
Suitable tools must be used for assembly.
Place the mounting plate on the wall as a template.
k
Use a level to ensure that the wallbox is leveled.
k
Mark out the drill holes.
k
Drill at the marked points using a drill bit suitable
k
for the wall material.
NOTE
When mounting, make sure that the mounting
plate and the underside of the housing are not
distorted or deformed.
Place the mounting plate behind the housing
k
together with the lower part of the PCE Wallbox
EV11 and fix both with 4 pan-head screws suitable
for the wall condition. The max. torque of 120 Ncm
must not be exceeded.
For initial startup, follow the „Electrical connec-
k
tion" instructions (page 34 / chapter 6.5)
DE
EN
120 Ncm
31