Prepare The Instrument; Power On Or Off - Baker Hughes Druck DPI 800 Bedienungsanleitung

19. The data on the display is on hold. To continue, press the HOLD button again.
20. Shows the battery level: 0 ... 100%.
21.
Identifies the type of data and the measurement range.
Refer to: Select Task (Table 2 & Table 3)
22. ... 23.
Identifies the settings applied to the input.
Refer to: Settings (Table 4)
22. xxxx g The units and the type of sensor (If applicable) OR a specified scale (x:y).
23. Shows the settings applied to the measured value (If applicable).
24. A soft-key function. To select an available function, press the soft-key below it.
Example:
25. The measured value or values applicable to the task selection.
26. The Edit display to set up text labels (£ 6 characters): x:y Scaling (Table 4).
OK
Shift
BS

1.3 Prepare the Instrument

Before you use the instrument for the first time:
• Make sure that there is no damage to the instrument, and that there are no missing items.
• Remove the plastic film that protects the display. Use the tag () in the top right-hand corner.
• Install the batteries (refer to Figure B1). Then re-attach the cover.

1.4 Power On or Off

To turn the instrument on or off, press  (Figure A1 - item [1]). The instrument does a self test
and then shows the applicable data.
When the power is off, the last set of configuration options stays in memory. Refer to
"Maintenance" on page 18.
= Input
= Filter
= Tare
= Move left
= Accept the new text label
= Change the keys: 123ABC or -_+abc
= Add a space
= Back space (Delete character)
= IDOS input
= Maximum
= Average
= Minimum
= Move right
Copyright 2003 Baker Hughes Company.
English–DPI 800/802 Instruction Manual | 5