Upm Pressure Measurements; Error Indications; Maintenance - Baker Hughes Druck DPI 800 Bedienungsanleitung

2.8 UPM Pressure Measurements

Read all the instructions supplied with the UPM and then use the specified procedures to connect
it (Figure 8).
Figure 8: Example Configuration - Pressure Measurement with a UPM
When the connections are complete, make the necessary IDOS selections (Table 2/Table 3).
Then use the same procedures as specified for the P1/P2 connections.
If you re-attach a UPM, the instrument uses the same measurement units that you used before.
The instrument keeps a record for the last 10 modules.

2.9 Error Indications

If the display shows <<<< or >>>>:
• Make sure that the range is correct.
• Make sure that all the related equipment and connections are serviceable.

3. Maintenance

This section gives procedures to maintain the unit in a good condition. Return the instrument to
the manufacturer or an approved service agent for all repairs.
Do not dispose of this product as household waste. Use an approved organization that collects
and/or recycles waste electrical and electronic equipment.
For more information, contact one of these:
• Our customer service department: Druck.com
• Your local government office.
Copyright 2003 Baker Hughes Company.
18 | DPI 800/802 Instruction Manual–English
IDOS ... g
IDOS
MENU
ESC
OK
HOLD
IDOS 30 ... g
MENU
OK
30 ... g
5.03
=
Settings
a) Pressure
IDOS
MENU
OK
30 ... g
15.03
15.88 (@16:11:18)
- (@16:11:35)
15.74
0.14
2.76 ... /min
Start Settings
b) Leak test