Set Up The Basic Operation - Baker Hughes Druck DPI 800 Bedienungsanleitung

1.5 Set up the Basic Operation

Use the Set Up menu to set up the basic operation of the instrument.
1
MENU
OK
If there is additional data for a menu option, select Settings () to see the values that are set
up. If necessary, adjust the values.
Options
Description
(If applicable)
DPI 802/802P only. To add a series resistor into the mA circuit. You can then use this
instrument together with a HART® communicator to set up and calibrate HART®
devices.
To select and set up the backlight facility + timer.
Additional data: Select Settings ()
To select and set up the power off facility + timer.
Additional data: Select Settings ()
To show the battery level (%).
To set the display contrast (%).
 Increases %, decreases %
To set the time + date. The calibration facility uses the date to give service and
calibration messages.
To set the language option.
To calibrate the instrument.
Additional data: Refer to "Calibration" on page 19.
To select and show the applicable status data (Software Build, Calibration Due date,
Serial Number, IDOS Information).
Copyright 2003 Baker Hughes Company.
6 | DPI 800/802 Instruction Manual–English
Menu:
2
Select Task


(Table 2)
Table 1: Menu Options - Set up
Menu:
3
Set Up
MENU
OK
(Table 1)
4 5
MENU

OK

[]/[ ]