Edit Functions - Baker Hughes Druck DPI 800 Bedienungsanleitung

Options
(If applicable)

1.8 Edit Functions

Example 1) Set up a label for x:y Scaling = %
mA
+04.000
+20.000
Sk1
Sk1 = Edit
Table 4: Menu Options - Settings
Description
To select and set up a tare value for the measurement task (a specified value
or the reading on the display).
The instrument subtracts a positive tare value, and adds a negative tare
value.
Additional data: Select Settings ()
To select and set up a scale of values: One local scale for each
measurement task (Maximum: 5).
Additional data (Example 1/2): Select Settings ()
To select and set up the filter values to give a smoother output for the
measurement task:
Band as a % of full scale (FS). The filter compares each new value with
the previous value. If the new value is outside the band, it is not filtered.
Low pass filter time constant in seconds. Increase the value to increase
the damping factor.
Additional data: Select Settings ()
To select and set up the alarm values for the measurement task (maximum
and minimum).
Additional data: Select Settings ()
Leak Test only. To set an applicable period for the leak test
(Hours:Minutes:Seconds).
Settings
1
x:y
123ABC
=
+04.000
 
=
+20.000
Edit
_
- _ + . % ^ & * / \
q w e r t y u i o p
a s d f g h j k l
z x c v b n m
OK Shift BS
Figure A3 - item
[26]
2
Edit
_
1 2 3 4 5 6 7 8 9 0

Q W E R T Y U I O P

A S D F G H J K L

Z X C V B N M
OK Shift BS
Figure A3 - item
[26]
... Edit
%_
OK

3
Edit
MENU
Shift OK
4 5

MENU
OK

Copyright 2003 Baker Hughes Company.
English–DPI 800/802 Instruction Manual | 9