To Start; Location Of Items (Refer To Figure A1 And Figure A2); Items On The Display (Refer To Figure A3) - Baker Hughes Druck DPI 800 Bedienungsanleitung

1. To Start

1.1 Location of Items (Refer to Figure A1 and Figure A2)

Item Description
1. On or Off button.

2. Left-hand soft-key. Selects the function above it on the display (Item 24). Example:

Edit
3. Moves back one menu level.
ESC Leaves a menu option.
Cancels the changes to a value.
4. Increases or decreases a value.

Highlights a different item.

5. HOLD Holds the data on the display. To continue, press the HOLD button again.
6. Shows the Select Task menu.
MENU
Selects or accepts an item or value.
OK
Selects [] or cancels [ ] a selection
7. Right-hand soft-key. Selects the function above it on the display (Item 24). Example:

Settings
8. Display. Refer to Figure A3
9. SENSOR/ Communications port. Use to connect a Universal Measurement Module (UMM) or
PC a RS232 cable.
10. 10a. IDOS pressure connector with identification marks. Refer to "Safety" on page 1.
Label to identify the pressure range for the associated IDOS pressure connector
10b.
(P1/P2): Sealed gage (sg), gage (g), absolute (a).
PTFE vent filter or a reference port connector. Refer to "Specification Data" on
10c.
page 22.
11. Connection point for some of the optional accessories. Refer to the datasheet.
12. Battery compartment. Refer to Figure B1.
13., 14., 15. DPI 802/802P only. Terminals to measure current, to supply 24V source, and to do
switch tests.

1.2 Items on the Display (Refer to Figure A3)

Item Description
16. DPI 802/802P only. Task indication for the switch test.
Task indication for the leak test.
Refer to: Select Task (Table 2 & Table 3)
17.
DPI 802/802P only. The loop power supply is on.
Refer to: Select Task (Table 2 & Table 3)
18.
The measured value satisfies one of the alarm conditions. Refer to: Settings (Table 4)
Copyright 2003 Baker Hughes Company.
4 | DPI 800/802 Instruction Manual–English
= switch closed
= switch open