Troubleshooting - IKEA LAGAN Handbuch

ENGLISH
When the cleaning is completed, install the
glass panel and the oven door. Do the
above steps in the opposite sequence.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame on the screen-printing zones is
not rough when you touch it.
Make sure that you install the internal glass
panel in the seats correctly.

Troubleshooting

Warning! Refer to Safety
chapters.
What to do if...
Problem
The oven does not heat up.
The oven does not heat up.
Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
3. Turn the lamp glass cover
4. Clean the glass cover.
5. Replace the oven light bulb with a 25
6. Install the glass cover.
Possible cause
The oven is deactivated.
The fuse is blown.
Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
deactivate the circuit breaker.
counterclockwise to remove it.
W, 230 V (50 Hz), 300 °C heat resistant
oven light bulb (connection type: E14).
Activate the oven.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
14
Remedy