Installing The Product - Beko BHCA66641BBHS Installationsanleitung

EN - Safety instruction
• Product must be installed by a qualified
person in accordance with the regulations
in force. The manufacturer shall not be
held responsible for damages arising from
procedures carried out by unauthorized
persons which may also void the warranty.
• Preparation of location and electrical
installation for the product is under
customer's responsibility. Before calling
the Authorized Service, make sure that the
electrical installation is suitable. If not, call a
qualified electrician to make the necessary
arrangements.
• The product must be installed in
accordance with all local electrical
regulations.
• Before installing the product, remove all the
materials and documents in it and visually
check if the product has any defects on it.
If so, do not have it installed.
• The product is heavy, carry the product
with at least two people
• Disconnect electrical connections in the
area to be installed before installation.
• Failure to install screws or fixing equipment
in accordance with the instructions may
result in electrical hazard.
• There may be sharp surfaces on product
parts. Always wear protective gloves for
installation.
• If the product is not fastened sufficiently,
there may be a risk of falling. Make sure
that all fixings are securely fastened.
• The width of the hood should be at least
equal to the width of your hob.
• The dimensions given in the installation
diagrams are in mm.
• The air to be exhausted with the hood should
not be given to a chimney used by other
devices burning gas or other fuels. (Not only
for devices that return air to the room)
• Regulations regarding the exhaust of air
must be followed.

Installing the product

Product dimensions and security
measures (Picture 1-2)
• Pay attention to product dimensions.
Check the suitability for your furniture.
(Picture 1)
• The height between the lower surface of
your hood and the upper surface of the
hob should not be less than 650 mm for
gas hobs, 500 mm for electrical hobs.
(Picture 2)
* In the installation pictures, a demonstration
on the gas hob was made as an example,
and the size that should be left on the hob
was shown as 650 mm. If you have an
electric hob, take this measurement as 500
mm as a reference.
Control and preparation of the wall to
be installed
• The wall on which the product will be
installed must be in an upright and flat
position that has the carrying power of the
product.
• There must be no water, electricity and gas
connections on the wall to be installed and
around the holes to be drilled.
Connecting the appliance to the
electricity supply
• Manufactured with 2-track power cable,
this device must be connected to the
mains by an electrical switch with at least
3mm clearance between bipolar contact
leads. Have the electrical connections done
by a qualified electrician.
• Before starting any work on the electrical
installation, disconnect the product from
the mains supply. There is the risk of
electric shock!
• The product must be connected to the
mains supply only by an authorised and
qualified person. The product's warranty
period starts only after correct installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
• Install your appliance so that you can reach
the power connection (plug, outlet) easily
after installation.
• If your product has been produced with
plug, do not cut the plug to connect
to electrical supply during installation.
Otherwise, the warranty becomes void and
the safety risks may happen for users.
Installation dimensions and details
(Picture 3-4))
• The dimensions in which the product can
be installed with a double chimney are
shown in picture 3b.
9