Cleaning, Checks And Storage/ Troubleshooting - Christopeit Sport AX 6000 Montage- Und Bedienungsanleitung

CLEANING, CHECKS AND STORAGE
1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene, thinner or other aggressive cleaning agents for surface cleaning as this dam-
age caused. The device is only for private home use and for use suitable indoors. Keep the unit clean and moisture from the device.
2. Storage
Remove the batteries from the computer while intending the unit for more than 4 weeks not to use. Choose a dry storage in-house and put some
spray oil at front & rear foot tube connection point and hand grip axle. Also to the thread of the mounting screws for handle and seat tube. Cover
the bike to protect it from being discolor by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for tightness, which were prepared in the assembly. Every 100 operating hours,
you should put some spray oil at front & rear foot tube connection point and hand grip axle.
TROUBLESHOOTING
If you cannot solve the problem with the following information, please contact the authorized service center.
Problem
Computer has no value at Dis-
play if you press any key.
Computer is not counting data
and do not switch on after start
cycling.
Computer is not counting data
and do not switch on after start
cycling.
No pulse value.
No pulse value.
Resistance don't change
(for home trainer and user)
Possible Cause
No power adapter is well plugged or wall
power is without power.
Sensor impulse missing base on not well
plugged connection.
Sensor impulse missing base on not cor-
rect position of sensor.
Pulse cable is not plugged in.
Pulse sensors not well connected.
Connection of resistance not well
Training area in mm
Solution
Check that the power adapter is properly plugged in, possibly
with another electric device check if the wall power is fine.
Check the plug connections at computer and inside of handle-
bar support.
Take off the cover and check the distance between magnet and
Sensor. The magnet at turning belt wheel should have only less
than < 5mm distance against the sensor position.
Check the separately pulse cable is well connected with compu-
ter. Check the connections of the pulse cable.
Screw out the screw for pulse measurement and check if plugs
are well connected and no damage at pulse cable.
Check the resistance connection inside of handlebar support as
manual mention.
Free area in mm
(Training area and security area
(rotating 60cm))
19
GB