Technoline WS 9117 Betriebsanleitung Seite 38

2. Insert the batteries in the first transmitter.
3. Within 2 minutes of powering up the first transmitter, insert the batteries in the
Temperature Station. Once the batteries are in place, all segments of the LCD will
light up briefly. Following the indoor temperature and the time as 0:00 will be
displayed. If these informations are not displayed on the LCD after 60 seconds,
remove the batteries from both units and wait for at least 60 seconds before
reinserting them.
4. The outdoor temperature from the first transmitter (channel 1) should then be
displayed on the Temperature Station. Also, the signal reception icon will be
displayed. If this does not happen after 2 minutes, the batteries will need to be
removed from both units and reset from step 1.
5. Insert the batteries in the second transmitter as soon as the outdoor temperature
reading from the first transmitter are displayed on the Temperature Station.
Note : User shall insert the batteries into the second transmitter within 45 seconds after
37