Safety Information; Intended Use - Fora Diamond CUFF BP Bedienungsanleitung

Safety Information

Read the following Safety Information thoroughly before using the
device.
• Use this device ONLY for the intended use described in this manual.
• Do NOT use accessories which are not specified by the
manufacturer.
• Do NOT use the device if it is not working properly or damaged.
• Do NOT use under any circumstances on newborns, infants, or
persons who cannot communicate.
• This device does NOT serve as a cure for any symptoms or diseases.
The data measured is for reference only. Always consult your
physician to have the results interpreted.
• Keep the equipment away from hot surfaces.
• Do NOT apply the cuff to areas other than the place directed.
• Proper maintenance and periodically calibration are essential to the
longevity of your device. If you are concerned about your accuracy
of measurement, please contact local customer service for help.
• If you experience any serious incident that occurred in relation to
the use of this product, please report it to the manufacturer and the
competent authority of medical devices in your country.
• A serious incident means any incident that directly or indirectly led,
might have led, or might lead to any of the following:
(a) the death of a patient, user, or other people,
(b) the temporary or permanent serious deterioration of a patient's,
user's or other person's state of health,
(c) a serious public health threat.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE
Introduction

Intended Use

The Diamond CUFF BP Blood Pressure Monitoring System is intended
to be used to measure the systolic and diastolic blood pressure and
pulse rate by using a non-invasive technique in which an inflatable
cuff is wrapped on the upper arm.
The device also works in unison with iFORA BP app that enables
transmission and sharing capabilities via Bluetooth.
Do not use this system on babies, young children or persons who
cannot express their consent.
Test Principle
Blood pressure is measured non-invasively at the arm based on
oscillometric method.
The reading obtained by single and average mode which use
oscillometic method is for reference only.
EN-1