Fitting The Cuff - Fora Diamond CUFF BP Bedienungsanleitung

Note:
• If the device is left idle for 3 minutes, it will turn off automatically.
• The Bluetooth pairing process is only required when user needs to
pair this device to a Bluetooth receiver for the first time, or when
user needs to pair this device to another new Bluetooth receiver.
Testing Your Blood Pressure
Before Measument
• Avoid caffeine, tea, alcohol and tobacco for at least 30 minutes
before measurement.
• Wait 30 minutes after exercising or bathing before measurement.
• Sit or lie down for at least 10 minutes before measurement.
• Do not measure when feeling anxious or tense.
• Take a 5-10 minute break between measurements. This break can be
longer if necessary, depending on your physical conditions.
• Keep the records for your doctor as reference.
• Blood pressure varies between each arm. Always measure your
blood pressure on the same arm.

Fitting the Cuff

1. Assemble the cuff.
The smooth surface should be inside the cuff loop and the metal
D-ring should not touch your skin.
Note:
• Before using the cuff, be sure the cuff size fits with your upper
arm circumference.
2. Stretch your left (right) arm in front of you with your palm facing
up. Slide and place the cuff onto your arm with the artery mark
region (in red) toward the lower arm.
Wrap and tighten the cuff above your elbow. The red line on the
edge of the cuff should be approximately 2 to 3 cm (0.8 to 1.2
inches) above your elbow.
25~35cm 2~3cm
9.4"~16.9" 0.8"~1.2"
3. Leave a little free space between the arm and the cuff. You should
be able to fit 2 fingers between them.
4. Press the hook material firmly against the pile material. The top
and bottom edges of the cuff should be tightened evenly around
your upper arm.
Proper Measurement Position
1. Sit down for at least 10 minutes before measuring.
2. Place your elbow on a flat surface. Relax your hand with the palm
facing up.
3. Make sure the cuff is about the same height as the location of your
heart.
EN-4