Troubleshooting - Fora Diamond CUFF BP Bedienungsanleitung

Caring for Your Device
• To clean the device exterior, wipe it with a cloth moistened with tap
water or a mild cleaning agent, then dry the device with a soft dry
cloth. Do NOT flush with water.
• Do NOT use organic solvents to clean the device.
• Do NOT wash or iron the pressure cuff.
Device Storage
• Storage condition: -25°C to 70°C, within 10%~95% relative humidity.
• Always store or transport the device in its original storage case.
• Avoid dropping and heavy impact.
• Avoid direct sunlight and high humidity.

Troubleshooting

If you follow the recommended action but the problem persists, or
error messages other than the ones below appear, please call your
local customer service.
Error Message
Error Message Cause
Inflation or
pressure error.
Blood Pressure
measurement
error.
What To Do
Please contact local customer
service for help.
Refit cuff tightly and correctly.
Relax and repeat the
measurement. If the error still
remains, please contact local
customer service for help.
Battery is too low.
Problem with the
device.
Blood Pressure Measurement
Symptom
Nothing is displayed
after pressing the
Power button.
The heart rate is
higher/lower than
user's average.
The result is higher/
lower than user's
average measurement.
EN-8
Replace the batteries.
Please contact local customer
service for help.
Cause What To Do
Replace the
Batteries exhausted.
batteries.
Batteries incorrectly Check that the
installed or no batteries are
battery is installed. correctly installed.
Movement during Repeat
measurement. measurement.
Rest at least
Measurement taken 30 minutes
just after exercise. before repeating
measurement.
May not be in correct Adjust to the
position while correct position to
measuring. measure.
Blood pressure
Keep in mind for
naturally varies from
next measurement.
time to time.